Electric Kettle
     Electric Kettle It is used to make hot water to use in the home as needed, such as brewed drinks, mixed water, clean dishes, etc. Electric kettles are currently used in three types, conventional and automatic release. Water pressure



Components of Electric Kettle
     1. Electric Kettle The only component is the heating wire.
Or heater is a nickel wire wrapped with magnesium oxide powder. Then covered with a metal tube. This heat exchanger is curved at the bottom of the kettle with two terminals out. To connect the plug to hot water. When there is electricity flowing through the wire, the heat will cause the wire to heat up. And the heat is transferred to the water until the water temperature reaches its boiling point.
If the water is boiling and not pull the plug out, the water will continue to evaporate until it evaporates.
Caution Use this kettle to be careful not to lower the water level than the heating wire. Damage can be caused because the heating wire is designed for water only.
2. Automatic kettle The bimetallic heat and temperature controls are responsible for cutting off electrical current flowing through the heat sink. The heater or heater of this kettle is both closed and semi-closed, whether it is a heater Any kettle that is used for this kettle is designed to work with water, requiring water in the bucket at all times. If the water is dry or below the specified level. It may cause damage to the heater. The temperature control of this type of kettle is mainly.
Bi-metallic, which is made of two different types of metal with a different growth rate, is attached tightly together when the sheet.
The bimetallic heat exchanger controls the contact to cut off the current flowing through the heater. This lamp indicates the operation of the kettle. That work Or cut off the work or show the water in the boiling temperature reached the desired point.
3. Air Pressure Automatic Electric Pots. This kettle is shaped like a bottle of water. But it looks like a kettle. Can keep the heat of warm water. Or hot as long as you want. This kettle has many important components.


1) The cover is the top cover of the lock. This cap acts as a compressor into the air. When the user presses the hand on the lid.
2) The inner cover is a round aluminum plate with rubber surrounds to prevent air leakage.
3) The structure has two layers: the outer and inner layers. The outer layer is insulated with water markers. Warm water boiler (Boil) The inner frame is an aluminum or stainless steel container for water in the lower part of the frame, with a magnetic plug.
4) Shake the power cord used with this kettle. One end is a plug with a pin. To plug into a home electrical plug. The other end is a magnetic plug for attaching to the connector of the To bring electricity into the kettle.
5) Thermal wire on the bottom of the check two sets of the first set of power is about 700 watts of hot water. Another set of power about 50 watts of treatment. Water temperature is constant.
6) The light bulb in the bottom frame has two bulbs: a warm light bulb. And the boiler light. Both bulbs tell the state of the kettle. While the machine is hot water. How to use electric kettle to boil water Pour the water into the kettle and plug it into the kettle. Then plug the other end into the power plug in the house. When the water is boiling or hot to the desired level. Unplug both sides.

how to presentation when metting tool

Video projectors are valuable and productive asset in using the modern technology of presentations. In business wherever presentations of a high quality is required, video projector is a useful IT tool. Schools and universities too are benefiting a lot from the usage of video projectors; it has in many ways changed the learning and teaching experience.